Voiture intelligente

Touchscreen Driver Install:

1. Copy UPDD Install File folder attached to this email onto a flash drive.
2. Install flash drive with UPDD install file into system
3. Navigate to Windows on the B220 unit by shutting down the B220 software
4. Navigate to UPDD Install File on installed flash drive and run “setup32”

1. NOTE: It may take several minutes for “setup32” to start up and run. Do not repeatedly click the application.

1. When UPDD install screen appears do not select any controllers, just select the install button
2. Installation box will appear and take roughly 3-5 minutes to complete
3. Once Install successful screen appears select the close button to hide the window.
4. At this point, remove all unnecessary USB inputs (Keyboard, mouse, flash drives etc.) and shut system down then reboot system.
5. Verify touchscreen is responding; if touchscreen is responding skip to step 14.If touchscreen is not responding continue to next step.
6. Remove top cover from B220 unit and navigate back to windows screen.
7. With cover off B220 unit, disconnect USB cable to touchscreen controller PCB on back side of touchscreen.
8. Reconnect USB cable to touchscreen controller PCB and look for window in bottom right of screen indicating new hardware recognized and installing. If this window is seen touchscreen should begin working shortly thereafter.
9. If after reconnecting touchscreen USB cable to PCB touchscreen persists to not function, repeat steps 3 through 12.
10. Once touchscreen begins to function follow the attached “UPDD Touchscreen Calibration” document attached.

If reinstallation fails repeatedly contact Services@implantsciences.com 

...